Product Description
The Anchor Point Ring is designed to be used with the Anchor Rail part 882. The Anchor Point Ring features a stainless steel ring for superior strength and holding power. They are extremely easy to use.
The Anchor Rings are super strong with an assembly break strength of 4000 lbs and work load limit of 1,333 lbs.
Fits
Part p/n 882, Anchor Rail, any length
Mounting
Simply make sure the clip of the stud fitting runs parallel with the rail. Put your thumb inside the ring and push down on the stud while lifting the clip with your index and middle fingers. You will see a round disk has been ejected from the clip. Insert this disc into the desired round cut-out of your rail.
Slide the Anchor Point Ring either direction so it is halfway between two of the tracks openings and let the clip fall on both sides of the fitting in the 2 round slots on both sides of the stud. Simply lift the clip and slide to adjust or remove from the rail.
Details:
- Strong stainless steel ring
- Anchor rings are easily installed, removed and adjusted in seconds.
- Anchor rings have an assembly break strength of 4000 lbs and work load limit of 1,333 lbs.
- Easily removable when not needed
- Sold Individually